Yamaha elb01e1 Manuel D’Utilisation

                                                     ELB-01 Owner’s Manual

181

Appendix

10

The Initial Touch function does not operate.

Adjust the Initial Touch settings in the Voice Condition display (page 42).

The Reverb effect is not applied to the desired Voice 
sections, even when the Reverb setting in the Voice 
Condition display Page 1 set to maximum. 

Increase the Reverb depth for the desired Voice sections in Reverb display.

The Rotary Speaker effect cannot be heard, even 
when the [ROTARY SP SPEED] button in the DISPLAY 
SELECT section is on.

Rotary Speaker must be selected first in Voice Condition display.

The pitch in the Single Finger mode does not change, 
even when pressing different keys of the keyboard.

Single Finger mode will only produce notes when played within a fixed octave 
interval on the Lower keyboard. If notes with the same letter name are pressed 
outside of that range, the chords that are sounded will share the same pitch.

While an Intro/Ending pattern is automatically playing, 
the Lower keyboard does not produce any sound, 
even when the keys are played.

Since the Accompaniment chords play automatically one after another, the 
Lower keyboard is designed not to produce any sound during the playback of 
an Intro/Ending pattern.

The Accompaniment cannot be heard even when an 
appropriate Accompaniment type is selected and the 
rhythm has been started.

• The Accompaniment volume may have been set to 0. Be sure to raise the 

• All Accompaniment parts may be set to off (mute). Set the desired part on 

The harmony notes of the Melody On Chord function 
cannot be heard.

The Upper keyboard has been set to sound only Lead Voices. Increase the 
volume of the Upper Keyboard Voices.

Certain functions have not been memorized to 
Registration Memory.

Recording or playback cannot be performed.

• The part buttons may have been turned off. Turn the desired part to REC or 

PLAY.

• The performance data is too large. The maximum limit for recording 

performance data is 1 MB.

• The media is write-protected. Cancel the write-protect.

• The media/folder may contain EL-format songs. You cannot record to the 

media/folder that contains EL-format songs. Create a new folder and record 
the song to it.

Recording is stopped before the performance is 
finished.

• The amount of recorded data on the media is close to the maximum limit. 

Either use another media or delete the data of unnecessary songs.

• When you overwrite the song, the length of a subsequently recorded part 

cannot exceed the length of the previously recorded parts. Delete the 
previously recorded song, then record again (page 121).

• The performance data is too large. The maximum limit for recording 

performance data is 1 MB.

An error message appears while entering a folder 
name or song name.

• The song/folder name is too long. The capacity is 50 characters.

• The song/folder name may be an invalid name. Refer to page 124.

• The path name is too long. The capacity of the path name is 234 

characters. Reduce the layer or shorten the song/folder name to shorten 
the path.

The rhythm does not start at the beginning of a 
recording, or stops in the middle of the performance.

The M.D.R. is designed so that the rhythm cannot be started at the very 
beginning of a recording. If you wish to use the rhythm, start it after the time 
indicator appears in the display.

The floppy disk cannot be formatted when you want to 
format an unformatted disk.

Recognizing an unformatted disk takes a few seconds after it is inserted. 
Wait about 30 seconds, then try to format again.

The notes of the recording are “stuck” and sound 
continuously.

During playback, you may have removed the USB flash memory or floppy 
disk. Whenever you wish to stop playback, always press the [STOP] button 
before removing the media.