Yamaha UX96 Manuel D’Utilisation

• This applies only to products distributed by Yamaha Canada Music Ltd.
• Ceci ne s’applique qu’aux produits distribués par Yamaha Canada Musique Ltée.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

(class B)

This product, when installed as indi-
cated in the instructions contained in 
this manual, meets FCC require-
ments. Modifications not expressly 
approved by Yamaha may void your 
authority, granted by the FCC, to use 
the product.

 When connecting this 

product to accessories and/or another 
product use only high quality shielded 
cables. Cable/s supplied with this 
product MUST be used. Follow all 
installation instructions. Failure to 
follow instructions could void your 
FCC authorization to use this product 
in the USA.

 This product has been tested 

and found to comply with the 
requirements listed in FCC 
Regulations, Part 15 for Class “B” 
digital devices. Compliance with these 
requirements provides a reasonable 
level of assurance that your use of this 
product in a residential environment 
will not result in harmful interference 
with other electronic devices. This 
equipment generates/uses radio 
frequencies and, if not installed and 
used according to the instructions 
found in the users manual, may cause 
interference harmful to the operation 

of other electronic devices. 
Compliance with FCC regulations 
does not guarantee that interference 
will not occur in all installations. If this 
product is found to be the source of 
interference, which can be determined 
by turning the unit “OFF” and “ON”, 
please try to eliminate the problem by 
using one of the following measures:

Relocate either this product or the 
device that is being affected by the 
interference. 

Utilize power outlets that are on differ-
ent branch (circuit breaker or fuse) 
circuits or install AC line filter/s.

In the case of radio or TV interfer-
ence, relocate/reorient the antenna. If 
the antenna lead-in is 300 ohm ribbon 
lead, change the lead-in to co-axial 
type cable.

If these corrective measures do not 
produce satisfactory results, please 
contact the local retailer authorized to 
distribute this type of product. If you 
can not locate the appropriate retailer, 
please contact Yamaha Corporation of 
America, Electronic Service Division, 
6600 Orangethorpe Ave, Buena Park, 
CA90620

The above statements apply ONLY to 
those products distributed by Yamaha 
Corporation of America or its 
subsidiaries.

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

(class B)