Yamaha yamaha av receiver rx-v373 rx-v373bl Manuel D’Utilisation

PREPARATIONS

➤ Optimizing the speaker settings automatically (YPAO)

En

• To cancel the operation, disconnect the YPAO microphone, or use the 

cursor keys to select “Exit” and press ENTER, before starting the 
measurement.

• Do not stand between the speakers and the YPAO microphone during the 

measurement process (about 3 minutes).

• Move to the corner of the room or leave the room.

The measurement will start in 10 seconds. Press ENTER to 
start the measurement immediately.

• To stop the measurement temporarily, press RETURN and follow the 

procedure in “Error messages” (p.31).

The following screen appears on the TV when the 
measurement finishes.

1

2

3

4

• If any error message (such as E-1) or warning message (such as W-1) 

appears, see “Error messages” (p.31) or “Warning messages” (p.32).

• A speaker with a problem is indicated by blinking of the speaker indicators in 

the front display.

• If multiple warnings are given (when operating with the front display), use 

the cursor keys (q/w) to check the other warning messages.

To save the measurement results, use the cursor 
keys (e/r) to select “SAVE” and press ENTER.

The adjusted speaker settings are applied.

• To finish the measurement without saving the result, select “CANCEL”.

This completes optimization of the speaker settings.

1
2
3
4

• The YPAO microphone is sensitive to heat, so should not be placed anywhere 

where it could be exposed to direct sunlight or high temperatures (such as on 
top of AV equipment).