Epson 3010E Manuel D’Utilisation

Making Detailed Adjustments

Use this menu to adjust 3D brightness, the 3D display format and other 3D settings. 

Note: You should only adjust the 3D Format and Inverse 3D Glasses

 

settings if 3D images aren’t 

displaying correctly. Changing these settings unnecessarily may cause problems with 3D 
projection.

■

3D Display

Enables or disables 3D mode. You can also change this setting by pressing the 

2D/3D

 

button on the remote control.

■

3D Format

Use this setting to select the 3D format supported by your video device. In most cases, the 
projector will correctly detect the 3D format when this option is set to 

Auto

. You should 

only select the 

2D

, 

Side by Side

, or 

Top and Bottom

 formats when your projector 

doesn’t properly display 3D images. See your video source documentation for 
information on which mode to select.

■

3D Brightness

Adjusts the brightness of 3D images. Select the 

Medium

 or 

High

 settings if the 3D 

display is too dark.

Note: This setting is not available when 3D Format is set to Auto.

■

Inverse 3D Glasses

Reverses the timing for the left and right shutters on the 3D active shutter glasses. Only 
enable this function if 3D images are not displaying correctly.

Note: This setting is not available when 3D Format is set to Auto.

■

3D IR Emitter

Select 

External

 if you’ve connected an external 3D IR emitter (see “Optional 

Accessories” on page 10 for ordering information).

Signal > 3D Setup > 3D Display

Signal > 3D Setup > 3D Format

Signal > 3D Setup > 3D Brightness

Signal > 3D Setup > Inverse 3D Glasses

Signal > 3D Setup > 3D IR Emitter

pl3010_3010e_UG.book  Page 45  Wednesday, September 7, 2011  6:28 PM