Aleratec 350117 Manuel D’Utilisation

www.aleratec.com

18

Power Requirements

Voltage: 100-240V

Current: 50-60Hz

Dimensions

(depth x width x height)

D: 201mm W: 210mm H: 120.3mm 

(7.9” x 8.3” x 4.7”)

Weight

1.02kg (2.2 Lbs.)

Note: Specifications subject to change without notice. 

If your HDD Copy Dock Duplicator is not performing as expected, refer to the 

symptoms below, and follow the suggested corrective action. 

LCD Display

If the LCD display does not display any message and 

the backlight is not lit after powering on the HDD Copy 

Dock Duplicator, check that the power cable is properly 

connected and that the ON/OFF switch is turned on.

Error Messages

While the system is performing an operation and the 

operation is manually terminated, an error message will 

be shown in the LCD display. This may lead to an failed 

operation and could cause the HDD Copy Dock Duplicator 

to stop responding. If this happens, power the unit off, wait 

about ten (10) seconds, and then reapply power.

Hard Disk

If the HDD Copy Dock Duplicator does not detect one 

of the hard disk drives, verify that the drive is properly 

connected. Power off all HDD’s. Wait 10 seconds then 

power on.

Keypad Buttons

If pressing the keys on the front panel produces no 

response from the system, the HDD Copy Dock Duplicator 

may still be busy with the previous operation. If the system 

is idle, power the unit off, wait about ten (10) seconds, and 

then reapply power.

Startup/Shutdown

Do not power off the system while it is performing an 

operation. After a normal shutdown, wait about ten (10) 

seconds before reapplying power.