Tascam DP-02 Manuel D’Utilisation
IMPORTANT SAFETY PRECAUTIONS
0
TASCAM DP-02/DP-02CF
2 – Advanced techniques
This function takes the section of a track or tracks marked
by the
by the
IN
and
OUT
points, and moves it to the chosen track
or tracks, inserting it as new material, starting at the TO
point.
point.
After the operation, the selected section of the source
between the
between the
IN
and
OUT
points is replaced by silence.
The insert operation adds the selected section as new mate-
rial to the destination. Nothing is overwritten on the desti-
nation, as any material following the TO point is moved to
the end of the newly-inserted section. The track is therefore
longer than it was before the operation.
rial to the destination. Nothing is overwritten on the desti-
nation, as any material following the TO point is moved to
the end of the newly-inserted section. The track is therefore
longer than it was before the operation.
OUT
IN
TO
OUT
IN
TO
You can change the following values:
SOURCE.TRK This sets the source track or tracks from
which the section is taken. Choose 1 through 8 to select an
individual track. Choose 1/2, 3/4, 5/6, 7/8 to select a pair of
tracks. Choose 1-8 to select all tracks.
which the section is taken. Choose 1 through 8 to select an
individual track. Choose 1/2, 3/4, 5/6, 7/8 to select a pair of
tracks. Choose 1-8 to select all tracks.
DESTINATION. TRK This sets the destination track or
tracks into which the selected section is inserted. What you
can select here depends on what you have selected for the
source track. If you have selected a single track, you can
select tracks 1 through 8 here. If you have selected a pair
of tracks (for instance, 1/2), you can only select track pairs
here. If you have selected all tracks (1-8), then this is the
only option available to you here.
tracks into which the selected section is inserted. What you
can select here depends on what you have selected for the
source track. If you have selected a single track, you can
select tracks 1 through 8 here. If you have selected a pair
of tracks (for instance, 1/2), you can only select track pairs
here. If you have selected all tracks (1-8), then this is the
only option available to you here.
Press
YES/ENTER
to perform the operation or
NO/EXIT
to
leave this screen.
MOVE
®
INSERT
This function “opens up” a silent gap between the
IN
and
OUT
points on the chosen track or tracks.
The source and destination are the same, and after the
operation, the track is split at the
operation, the track is split at the
IN
point, with the mate-
rial which followed the
IN
point now moved to follow the
OUT
point. The result is therefore longer than the original.
OUT
IN
OUT
IN
There is only one value that you can change:
OPEN.TRK Select an individual track (1 through 8), a
pair of tracks (1/2, 3/4, 5/6, 7/8), all of the tracks (1-8) or all
tracks (ALL).
pair of tracks (1/2, 3/4, 5/6, 7/8), all of the tracks (1-8) or all
tracks (ALL).
Press
YES/ENTER
to perform the operation or
NO/EXIT
to
leave this screen.
OPEN