Epson progression u11 Manuel D’Utilisation

3. Gently push the SIMM into the socket and then tilt it left

until it is vertical, guiding the holes at each end of the

SIMM over the retaining posts at each end of the SIMM

socket.

retaining post

hole

The SIMM should snap into place over the retaining posts.

If it does not go in smoothly, do not force it; pull it all the

way out and try again.

Make sure the SIMM is fully inserted into the socket and

that the pins on the retaining posts extend through the

holes in both ends.

4. If you are installing a second SIMM, repeat steps 2 and 3 to

install it in the other socket.

5. After you replace the computer’s cover, be sure to run the

SETUP program so your system can update its

configuration. See Chapter 2 of the Setup Guide for

instructions.

Installing and Removing Options

3-15