Auto Page rs-660 Manuel D’Utilisation

 

3

XT-33:  This transmitter uses  two (2) 3-volt lithium ion batteries 
(#CR2016) that are sandwiched together with the (+) side facing upward.  
To replace the battery, you will need to use a small flat blade screwdriver.  
Locate the small notch on the lower right side of the transmitter case next 
to the key ring.  Using the flat blade screwdriver, carefully pry the top 
case from the bottom case.  It should snap apart after breaking the seal.  
Before removing the batteries note the direction of the positive (+) 
terminal.  Place the new batteries in exactly the same manner, being 
careful not to bend or damage the contact terminal.  Snap the cases 
back together and then test the transmitter to insure it arms and disarms 
the alarm. 
 
 
 
 
 
 
 
 
 
 
 
 
 
ACTIVE LOCK & ARM: 
1. Press 

 button on the transmitter. 

2. The  siren will chirp once and parking lights will flash once indicating 

that the system is now armed. The vehicle doors will lock upon arming 
when interfaced with the keyless entry system. 

 
SILENT ARMING / DISARMING: Pressing the 

 + 

 buttons   

together on the transmitter will arm or disarm your system, No chirp 
sound will be heard, arm / disarm confirmation will be through the   
vehicles parking lights only. 
 
DEFECTIVE SENSOR REMINDER:  If the siren sounds 3 chirps, then 
you have left a door, trunk, or hood lid ajar.   
 
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS:   
Press the 

 button once: The siren chirps once, The system is armed. 

Press the 

 button a second time within 5 seconds: The siren chirps 

twice, the Shock Sensor is now bypassed. The sensor bypass feature is 
programmed to activate for one arming cycle only. The security system 

3-Volt Batteries