Epson equity ie q50188015-1 Manuel D’Utilisation

The Equity Ie uses a 25-pin, D-shaped male connector, so be sure you have a
compatible cable (or an adapting cable that converts the 25-pin output to

9-pin output). To connect a serial device, follow the steps above for

connecting a parallel device.

You need to make sure the serial port is set up so it functions properly. If you

are using the port for a serial printer, you must also redirect printer output to

the serial instead of the parallel port. Use the MS-DOS MODE command
(or the Epson MENU program) to make these changes. See your MS-DOS

manual for instructions.

Follow these steps to connect the power cord:

1. Make sure the power switch on the main unit is turned off.

1-8