Epson equity 3865x-20 plus Manuel D’Utilisation

The instructions in this chapter describe how to install and
remove optional Epson diskette and hard disk drives. All drives
sold by Epson for the Equity 386SX/20 PLUS are qualified and
recommended for use in this system. Your drive may look a bit
different from the one illustrated here, but you install it the
same way.

If you are installing or removing a non-Epson drive, some of
the steps may not apply to your drive; see the documentation
that came with the drive for more information.

Each section in this chapter describes a part of the process you
may need to perform. Here are the guidelines:

Before you perform any of the procedures described here,
follow the steps in Chapter 5 to remove the computer’s
cover and the subassembly.

If you are installing a hard disk drive or removing one and
leaving another in the computer, follow the steps under
“Setting the Hard Disk Drive Jumpers” on page 7-4.

If you are removing your only hard disk drive, see
“Removing a Hard Disk from the Vertical Position” on
page 7-21.

If you are installing or removing a diskette drive and you
currently have a hard disk drive installed in the vertical
mounting position, see “Removing a Hard Disk from the

Vertical Position” on page 7-21.

If you are installing or removing a diskette drive and you do
not have a hard disk drive installed in the vertical mounting
position, see “Installing or Removing a Disk Drive in the
Horizontal Position” on page 7-23.

Installing and Removing Disk Drives

7-3