Autostart as-1727 Manuel D’Utilisation

P. 8 User 

Guide

  

 
Flashing LED 

The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press 
and hold the 

 and 

 buttons on the transmitter. Keep holding the buttons until the 

parking lights flash three (3) times. At that point release the buttons.  The LED will toggle to its next 
state –i.e.: ON/OFF: 
There are three programmable options regarding the flashing LED: 

i.  The LED flashes once the starter kill is activated (passive or active arming) and will turn itself 

off once the user turns the key to the 

position. 

ii.  The LED is totally disabled and will not flash –it will turn on solid however when in valet 

mode. 

iii.  The LED will flash once the starter kill is activated but requires pressing the 

 button to 

turn itself off.  Failure to press the 

 button will make the LED flash even if the key is in 

the 

 position. 

Safe Start 

If this feature is enabled, the user must press the 

 button 2 times within 3 seconds to 

remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing 
with the transmitter. 
If swap start mode is selected, to remote-start your vehicle, press the 

button and then 

the 

 button. The 

 output can be activated by pressing the 

 button. 

Ignition-Controlled Door Locks 

This is an added security feature. If your remote starter was installed with the ignition-controlled 
door locks option, the doors will automatically be locked as soon as the ignition key is turned to the 

 position while the brakes are pressed. When the key is turned to the 

 position, 

the doors will automatically be unlocked. 
Ignition Re-lock 

On remote starters of this series, when ignition-controlled door locks are enabled and the ignition 
key is in the 

 position, should any door be unlocked and opened, all doors will be 

relocked next time the brake pedal is pressed. 
Secure Lock 

Before it can remote-start your vehicle, the remote starter must first disarm the factory security 
system. The secure lock feature may be required on certain vehicle models with factory security 
systems that automatically unlock the doors when the security system is disarmed. 
To keep your vehicle protected when the factory security system is disarmed for a remote start, 
secure lock will relock your doors as soon as the vehicle has started. Once the engine run cycle 
ends, secure lock will rearm your factory security system. 
Turbo Mode 

When left in turbo mode, the remote starter will keep the engine running for 60 seconds before 
shutting it down. This is to allow a turbocharger to idle down after the user leaves the vehicle. See 
Turbo Mode section on page 5. 
Remote Trunk Release 

If your system was installed with the remote trunk release option, you can open your trunk by 
pressing the 

 button.   

Engine Run Time 

If you have a gas engine, your remote starter can be programmed to run the engine for 4, 15, or 
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be 
programmed to run the engine for 9, 20, or 30 minutes (20 minutes default).