Siemens siemens network router mc35 Manuel D’Utilisation

MC35_SAT_01_v02.00

Page 40 of 65

11.01.2002

Test command

AT^SSTR=?

Response

^SSTR:(list of supported <state>s), (list of supported <cmdType>s)

OK

Read command

AT^SSTR?

Response

^SSTR: <state>, <cmdType>

OK

Parameters

<state> 

Remote-SAT interface states (refer to AT^SSTA)

<cmdType> Ongoing Proactive Command (values see chapter 1.1.4

“Command Type Values”). However, this information is valid during
states PAC and WAIT only.

Write command

AT^SSTR=
<cmdType>,
<status>
[,<itemId>]
[,<inputString>]

The TA is expected to acknowledge the ^SSTGI response with AT^SSTR to
confirm that the proactive command has been executed.
AT^SSTR will also provide any user information e.g. selected menu item.

Response

During execution of a Proactive Command after AT^SSTR a response
parameter line may be issued by the ME:

^SSTR: <pac>, <TermQualifier>, <TerminationCauseText>

<TerminationQualifier>

Unsigned Integer, range 0 – 255

0

If <TerminationQualifier> is equal to 0, the Proactive Command has
been successfully finished.

>0

If <TerminationQualifier> is not equal to 0 the Proactive Command
did not perform sucessfully.

<TerminationCauseText>

•

 

If <TermQualifier> is not equal to 0 the Proactive Command did not perform
sucessfully:
If <TerminationCauseText> is not an empty string, this text has to be shown
to the user for an appropriate time, e.g. 2 seconds. The text contains
information regarding the termination cause, e.g. in case of a failed dialling
process call barring through Call Control by SIM mechanism may be
indicated.
If <TerminationCauseText> is an empty string, the TA shall give an own
indication to the user.

•

 

If <TermQualifier> is equal to 0, the Proactive Command has been
successfully finished:
If <TerminationCauseText> is not an empty string, this text shall be shown
to the user for an appropriate time.

OK