Alliance Laundry Systems d355ie1b Manuel D’Utilisation
504524
7
Additional Security . . .
Torx security screws are available (as optional equipment
at extra cost) for securing both lower access panels to
each dryer base. Order part number 62853.
at extra cost) for securing both lower access panels to
each dryer base. Order part number 62853.
A Torx bit, part number 282P4, is available (as optional
equipment at extra cost) for installing the Torx security
screws.
equipment at extra cost) for installing the Torx security
screws.
A Torx bit holder, part number 24161, is available (as
optional equipment at extra cost) to be used with the Torx
bit.
optional equipment at extra cost) to be used with the Torx
bit.
Slide Extension . . .
(Metered Models)
Remove two slide extensions, four screws and
lockwashers from the accesssories bag (located in lower
cylinder) and install the extension on the top of the coin
slide.
lockwashers from the accesssories bag (located in lower
cylinder) and install the extension on the top of the coin
slide.
IMPORTANT: Slide extension must be attached to
top side of the coin slides to make them long enough to
activate the accumulator.
top side of the coin slides to make them long enough to
activate the accumulator.
NOTE: This dryer unit, as shipped from the factory,
does not include the coin slides, coin drawers, lock or
keys. These coin slide kits (or parts) must be ordered,
at extra cost, according to the purchaser’s
requirements direct from the coin kit manufacturer
of your choice.
does not include the coin slides, coin drawers, lock or
keys. These coin slide kits (or parts) must be ordered,
at extra cost, according to the purchaser’s
requirements direct from the coin kit manufacturer
of your choice.
Timer Cams . . .
(Metered Models)
The dryer timers are factory equipped with a 45 minute
timing cam. If this drying time is not suitable to your
installation, the following cams can be found in the
accessories bag (located in lower cylinder).
timing cam. If this drying time is not suitable to your
installation, the following cams can be found in the
accessories bag (located in lower cylinder).
ELECTRIC DRYERS
2-53242 Cams (30 Minutes)
2-53242 Cams (30 Minutes)
2-53240 Cams (60 Minutes)
GAS DRYERS
2-53242 Cams (30 Minutes)
2-53242 Cams (30 Minutes)
A 60 minute timing cam, Part No. 53240, is available for
the gas dryers as optional equipment at extra cost.
the gas dryers as optional equipment at extra cost.
Lower Front Panel Security . . .
(Optional)
(Metered Models)
For added security, remove the two screws (with
lockwashers) from accessories bag (located in lower
cylinder). Install screws as follows:
lockwashers) from accessories bag (located in lower
cylinder). Install screws as follows:
1. Unlock control panel.
2. Lift up on control panel and swing bottom of panel
out, then pull down and away from control cabinet.
3. Install the two screws down through holes in lower
flange of control cabinet and into top flange of lower
front panel.
front panel.