temco-tool 41dvdsn Manuel D’Utilisation

27

It is important to periodically perform a visual check of 
the pilot and the burner flames. Pilot flame is shown in 
Figure 51.  If the flames appear abnormal call a service 
person.

Fig. 50  Flame adjustment knob for SIT valve.

FP390

FLAME ADJUSTMENT KNOB

11/21/96

Turn 

counterclockwise

to increase

flame height

Turn clockwise

to decrease

flame height

This appliance venting system is designed and con-
structed to develop a positive flow adequate to remove 
flue gases to the outside atmosphere.
Any foreign objects in the venting system, except those 
designed specifically for the venting system, may cause 
spillage of flue gases.
To inspect the venting system, make sure the main gas 
valve is off.  Remove window frame assembly (Refer to  
Window Frame Assembly Removal Section).  Using a 
flashlight, check the area above the baffle in the com-
bustion dome.  Clean if necessary.

For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment 
knob located near the centre of the gas control. (Fig. 
50)

Fig. 51  Correct pilot flame appearance.

FP1229

FP1229

Pilot flames

11/02

TL122

Dv logs 

side view

12/11/03  djt

TL122

Twig

Back Log

Slot

Bracket

Bracket

Front Log

Fig. 49  Side view of logset.