Mitsubishi 4d68 Manuel D’Utilisation
4D68 ENGINE (E-W) -
Water Pump, Thermostat, Hose and Pipes
11A-7-2
INSTALLATION SERVICE POINTS
"AA THERMOSTAT HOUSING INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
the mounting surface.
Specified sealant:
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
"BA WATER OUTLET FITTING INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
the mounting surface.
Specified sealant:
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
"CA THERMOSTAT INSTALLATION
(1) Install the thermostat with the jiggle valve up as shown
(1) Install the thermostat with the jiggle valve up as shown
in the illustration.
"DA WATER INLET PIPE / O-RING INSTALLATION
(1) Wet the O-ring (with water) to facilitate assembly.
(1) Wet the O-ring (with water) to facilitate assembly.
Caution
D Keep the O-ring free of oil or grease.
D Secure the water pipe after the thermostat housing
has been installed.
"EA COVER INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
the mounting surface.
Specified sealant:
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
PWEE9609
E
Dec. 1996
Mitsubishi Motors Corporation
DEN0768
DEN0769
DEN0770
Jiggle valve
DEN0846
Back side of cover