Plantronics WO100 Manuel D’Utilisation

Page de 25
Plantronics Savi User Guide
15
Conferencing in up to three additional 
headsets
While on a call, you can subscribe up to three additional headsets 
to your base for conferencing. As you add headsets to the base, 
an additional headset icon will appear in the Plantronics Software 
screen with a number from 1 to 3 indicating the number of 
additional headsets subscribed to the base. 
Guests may conference in as described below: 
1
 
While you are on a call:
 
a) 
Place the guest's headset into primary user's 
charging cradle.
   
 
 
OR
 
b)
 Place the guest's headset into over-the-air 
subscription mode by pushing the headset volume 
up button for three seconds until the indicator light 
becomes solid green.
2
 
Briefly press (less than one second) the subscription 
button on the base.
 
  The subscription light will flash yellow and green.
3
 
the subscription light will then turn solid yellow and you 
will hear a tone in the master headset indicating that a 
guest wishes to join the call.
4
 
If you press the call control button on the master 
headset within five seconds, the guest is joined to the 
call. 
  If you do not press the call control button within five seconds, 
the request to join the call is rejected and the guest will hear an 
error tone in their headset.
5
 
Guests may leave the conference call by pressing their 
call control button.
 
  When they do you will hear a single tone in the master headset 
as each guest leaves the call.
To see how many headsets are subscribed to the base, refer to 
the lower left-hand corner of the Plantronics Software screen. The 
first headset is the master headset and the number inside the next 
headset is the number of guest headsets subscribed to the base. 
The examples below show 1, then 2, then 3, guest headsets 
subscribed to the base in addition to the master headset. 
1
2
3
Headset docked 
Headset undocked 
Double press the subscription 
button on the base. The 
subscription light will flash red 
and green. 
When the subscription 
light becomes solid green, 
the headset and base are 
subscribed to one another.
Double press the subscription 
button on the base. The 
subscription light will flash red 
and green. Press the volume up 
button on the headset for three 
seconds until the indicator light 
turns solid green. 
When the subscription light on 
the base becomes solid green, 
the headset and base are 
subscribed to one another. 
NOte
 If the subscription process times out after two minutes or 
if the subscription process fails, the subscription light will become 
solid red for four seconds and then return to its previous state. If 
this occurs, try to subscribe the headset again.
Subscribing a master headset
The headset and base are subscribed to each other at the factory.  
In the event that you need to subscribe a new master headset 
to the base you can do so one of two ways. You can subscribe 
a master headset to the base with the headset docked (secure 
subscription) or undocked (over-the-air subscription). In either 
case, the system must be idle (not on a call).
 
Muting the headset
You can mute/unmute the headset in the following ways: 
Headset 
Base 
Press the volume down button 
(at least 1½ seconds) until the 
base talk button indicator light 
for the active call becomes 
solid red.
Briefly pressing (less than one 
second) a red desk phone or 
PC talk button on the base will 
unmute the headset. You cannot 
mute the headset using the desk 
phone or PC talk buttons.