Philips az3068-37b Manuel D’Utilisation

– Volume not adjusted
• Adjust the VOLUME

– Power Cord not securely connected
• Connect the AC power cord properly

– Batteries flat / incorrectly inserted
• Insert (fresh) batteries correctly

– Headphones connected to the set
• Disconnect headphones

– Electrostatic discharge/interference
• Unplug the set. If batteries inserted, remove batteries

from the battery compartment. Press and hold
STANDBY ON 

y for 10 seconds, then re-plug /

replace battery supply, and try activating the set again.

– CD contains non-audio files
• Press SEARCH

∞ or §. once or more to skip to

a CD audio track, instead of the data file

– Electrical interference: set too close to TV, VCR or

• Move the set to increase the distance

– Batteries flat/ incorrectly inserted
• Insert (fresh) batteries correctly

– Distance/ angle between the set too large
• Reduce the distance/ angle

– Weak radio signal
• FM / MW: Adjust the FM / MW telescopic aerial

– CD-R(W) is blank/ not finalized
• Use a finalized CD-R(W)

– No CD inserted
• Inserted a suitable disc
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared

The CD skips tracks
– CD damaged or dirty
• Replace or clean CD

– shuffle or program is active
• Switch off shuffle / program

• Use a lower compression level to record CD tracks

into MP3/WMA format

– Disc damaged or dirty
• Replace or clean disc

– Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
– Use of incompatible cassette types 

• Only use NORMAL (IEC I) for recording

– Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space

If a fault occurs, first check the points listed below before taking the set for repair. If you are
unable to remedy a problem by following these hints, consult your dealer or service centre.