Philips mc118c3799 Manuel D’Utilisation
13
MC 118 / 22 page 13
English
TROUBLESHOOTING
WARNING
Do not open the set as there is a risk of electric
shock! Under no circumstances should you try to
repair the set yourself, as this will invalidate the
guarantee.
shock! Under no circumstances should you try to
repair the set yourself, as this will invalidate the
guarantee.
If a fault occurs, first check the points listed below before
taking the set for repair.
If you are unable to remedy a problem by following these
hints, consult your dealer or service centre.
taking the set for repair.
If you are unable to remedy a problem by following these
hints, consult your dealer or service centre.
Problem
Possible cause
Remedy
No sound /power
Volume not adjusted
Adjust the VOLUME
Headphones connected
Disconnect headphones
Mains lead not securely plugged to wall socket Plug in properly
Reversed left and
Speakers incorrectly connected
Connect properly: L to left, R to right
right sound/ no sound
from one speaker
TIMER/SLEEPER
from one speaker
TIMER/SLEEPER
Clock time not set
Set the correct clock time
does not work
Severe radio hum or Electrical interference: set too close to TV,
Severe radio hum or Electrical interference: set too close to TV,
Increase the distance
noise
VCR or computer
Poor radio reception Weak radio signal
FM: Direct the FM aerial wire for optimum
reception
reception
NO DISC indication CD badly scratched or dirty
Replace/ clean CD, see Maintenance
CD-R(W) is blank or the disc is not finalised
Use a finalised CD-R(W)
Laser lens steamed up
Wait until lens has cleared
The CD skips tracks CD damaged or dirty
Replace or clean CD
SHUFFLE or PROGRAM is active
Switch off SHUFFLE / PROGRAM
Poor cassette sound Dust and dirt on the heads, etc.
Clean deck parts, see Maintenance
quality
Use of incompatible cassette types
Only use NORMAL (IEC I) for recording
(METAL or CHROME)
Recording does not
Cassette tab(s) may be broken
Apply a piece of adhesive tape over the missing
work
tab space.
Remote control does Batteries exhausted
Insert fresh batteries
not function properly Batteries incorrectly inserted
Insert the batteries correctly
Distance/ angle between the set too large
Reduce the distance/ angle.
TECHNICAL DATA
Amplifier
Output power . . . . . . . . . . . . . . . . . . . . . . . 2 x 5 W RMS
Output power. . . . . . . . . . . . . . . . . . . . . . . . 150 W PMPO
Signal-to-noise-ratio . . . . . . . . . . . . . . . . .
Output power . . . . . . . . . . . . . . . . . . . . . . . 2 x 5 W RMS
Output power. . . . . . . . . . . . . . . . . . . . . . . . 150 W PMPO
Signal-to-noise-ratio . . . . . . . . . . . . . . . . .
≥
65 dBA (IEC)
Input sensitivity AUX . . . . . . . . . . . . . . . . 0.5 V (max. 2 V)
Impedance loudspeakers . . . . . . . . . . . . . . . . . . . . . . 8
Impedance loudspeakers . . . . . . . . . . . . . . . . . . . . . . 8
Ω
Impedance headphones . . . . . . . . . . . . . . . 32
Ω
-1000
Ω
Tuner
FM wave range. . . . . . . . . . . . . . . . . . . . . 87.5 - 108 MHz
MW wave range . . . . . . . . . . . . . . . . . . . . 531 - 1602 kHz
LW wave range . . . . . . . . . . . . . . . . . . . . . . 153 - 279 kHz
Sensitivity at 75
FM wave range. . . . . . . . . . . . . . . . . . . . . 87.5 - 108 MHz
MW wave range . . . . . . . . . . . . . . . . . . . . 531 - 1602 kHz
LW wave range . . . . . . . . . . . . . . . . . . . . . . 153 - 279 kHz
Sensitivity at 75
Ω
– mono, 26 dB signal-to-noise ratio . . . . . . . . . . . . 2.8
µ
V
– stereo, 46 dB signal-to-noise ratio . . . . . . . . . . 61.4
µ
V
Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
≥
28 dB
Total harmonic distortion . . . . . . . . . . . . . . . . . . . . .
≤
5%
Frequency response . . . . . . . . . . . . 63 - 12500 Hz (± 3 dB)
Signal-to-noise-ratio . . . . . . . . . . . . . . . . . . . . .
Signal-to-noise-ratio . . . . . . . . . . . . . . . . . . . . .
≥
50 dBA
CD player
Frequency range . . . . . . . . . . . . . . . . . . . . . 20 - 20000 Hz
Signal-to-noise-ratio . . . . . . . . . . . . . . . . . . . . . . . 75 dBA
Tape deck
Frequency response
– Normal tape (type I) . . . . . . . . . . . 120 - 10000 Hz (8 dB)
Signal-to-noise-ratio (without Dolby NR)
– Normal tape (type I) . . . . . . . . . . . . . . . . . . . . . . 48 dBA
Wow and flutter. . . . . . . . . . . . . . . . . . . . . . .
Frequency range . . . . . . . . . . . . . . . . . . . . . 20 - 20000 Hz
Signal-to-noise-ratio . . . . . . . . . . . . . . . . . . . . . . . 75 dBA
Tape deck
Frequency response
– Normal tape (type I) . . . . . . . . . . . 120 - 10000 Hz (8 dB)
Signal-to-noise-ratio (without Dolby NR)
– Normal tape (type I) . . . . . . . . . . . . . . . . . . . . . . 48 dBA
Wow and flutter. . . . . . . . . . . . . . . . . . . . . . .
≤
0.4% DIN
Speakers
Bass reflex system
Dimensions (wxhxd) . . . . . . . . . . . . . . . . . 155 x 220 x 220
General
Dimensions (wxhxd) . . . . . . . . . . . . . . . . . 140 x 223 x 253
Weight (with / without speakers) . . . . approx 6.0 / 2.8 kg
Standby power consumption . . . . . . . . . . . . . . . . . . < 2 W
Bass reflex system
Dimensions (wxhxd) . . . . . . . . . . . . . . . . . 155 x 220 x 220
General
Dimensions (wxhxd) . . . . . . . . . . . . . . . . . 140 x 223 x 253
Weight (with / without speakers) . . . . approx 6.0 / 2.8 kg
Standby power consumption . . . . . . . . . . . . . . . . . . < 2 W
Subject to modification