Ultra Start 2500m Manuel D’Utilisation

Page de 4
Owners Guide
Self Learning Shock Sensor
1. Press & release the      button. 
2. The Park lights will flash and the siren will chirp once.
3. When the  vehicle has started, the system will  flash the park lights four times and       
then remain “On” while the vehicle is running.  
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).  
Extended Runtime
1. Press & release the    
 button while the vehicle is running.
2. The system will respond with a park light flash and  siren chirp  to confirm the runtime  
has been Extended. The system will reset to the default runtime, (normally 15 minutes).
Remote Start
Reservation Mode - Manual Transmission Models Only
3 sec.
Remote Stop
1. Press and hold the       button for three  seconds. The remote starter will shut down.
2. The park lights will flash two  times and the siren will chirp  two times.
Note: Pressing the brake pedal or opening hood will also stop the  vehicle.
Idle Mode
1. While the vehicle is running with key, press  the        button. 
2. The park lights will turn on and the siren will chirp once.
3. Turn the ignition key “off” and the vehicle will continue to run.
4.  Exit the vehicle and leave it running safely without the keys in the ignition.  Lock the 
door while the vehicle is left running.
While
running
Press &
Release
REMOTE STARTER FEATURES
Diagnostics
1st
2nd-6 sec.
3
1) Press the LOCK button on the remote five times in a row, the siren should chirp three  times and  
    the park lights should turn On and  remain On while in Learn Mode..
2) While the park lights are On, strike the vehicle with a sharp impact at the force  to trigger the alarm.
3) The system will respond with one siren chirp to confirm the impact has been learned. To exit Learn Mode, press the lock 
or unlock button on the remote transmitter.
PARK LIGHTS
STATUS LED
DIAGNOSTIC CODE
3 Flashes
Series of 3 Flashes
Door Opened “M” Models
4 Slow Flashes
Series of 4 Flashes
Not in Reservation Mode “M” units
5 Flashes
Series of 5
Flashes
Hood Pin Grounded (Open)
6 Flashes
Series of 6 Flashes
Brake Pedal Shutdown
7 Flashes
Series of 7 Flashes
Tach Lock-Out
8 Flashes
Series of 8 Flashes
3 Start Attempts with no start
1. With the vehicle running, apply the park brake then press & release the brake pedal.  
2. The park lights will flash to confirm that  reservation mode has been  activated.
3. Remove key from Ignition, and exit the vehicle. (the vehicle will remain running) 
4. *Close the door and the vehicle will shut off.
*If the vehicle has a delay dome-light, the vehicle may run until the dome-light turns off.
5)  
The vehicle is know in Reservation Mode and may be remote started.
Note: Opening a door after this point will cancel Reservation Mode. 
Timer / Optional Temp Start
1.Press & release  the #
 button, then press and hold the      button for six seconds, until the 
parking lights turn “on”. 
2. While the  parking lights are “on” the start cycle   can be selected.
1 hour cycle 
or 0C          Press   LOCK      button
       1 flash                             
2 hour cycle
or -5C         Press   UNLOCK button              2 flashes
3 hour cycle 
or -15c        Press     
button               3 flashes
    4 hour cycle  
or -25c        Press            
button               4 flashes
3. System will start vehicle at selected cycle for up to 24 hours.
4.  The temp start must have the temp sensor installed and will only trigger 1 time each 2 
hours if the sensor is not installed the unit will activate the timer mode.
TO CANCEL COLD START MODE
1. Press & release  the #
 button, then press and hold the      button for four seconds.
2. The park lights will flash and the siren will chirp twice.
#