Metrologic Instruments SP5600 Manuel D’Utilisation

 

18

S

YMPTOM

 

D

ESCRIPTION

 

Make sure the battery is inserted and charged. 

Charge the battery and check the charging status. If no charging information shown on 
the display, reload the battery and check if the battery is properly installed then try again.

Does not power up after 

pressing POWER key. 

Call for service if problem persists. 

Check if the cable is plugged tightly into host device and cradle. 

Perform Echo test to confirm communication. 

Cannot transmit data or 

programs to/from the terminal  Check if host communication parameters (COM port, baud rate, data bits, parity, and 

stop bit) match with the Terminal's. 
Verify that the communication port on the host device is not in use by another device. 

Turn off the power then enter the system menu.   From the system menu, select the Test 
and then its sub-item KBD.  Perform the key-in test. 

Keypad does not work 

properly 

Call for service if problem persists. 

Check if the bar codes used are enabled 

Check if battery-low indicator is shown on the LCD display. If yes, charge the battery 

Scanner does not scan 

Call for service if problem persists. 

Open the battery cap and re-load the battery. 

Enter system menu.  Run diagnostic test. 

Abnormal responses 

Call for service if problem persists.