Konica Minolta 4030-7764-02 Manuel D’Utilisation
3
3.7 Using the Touch Panel
3-22
Di2510/Di3010/Di3510
B
e
fo
re
Ma
ki
ng
C
o
pi
es
Chap
ter
3
Memory Recall
After printing of a copy job is finished, the image that was just copied can be printed
again without the document being loaded.
again without the document being loaded.
✎
Note
The memory recall feature is only available if the “Memory Recall” function (a
User’s Choice function in the Utility mode) is set to “ON”. For details, refer to
“Utility Mode Operations” in the Advanced Operations volume of the User Man-
ual.
The memory recall feature is only available if the “Memory Recall” function (a
User’s Choice function in the Utility mode) is set to “ON”. For details, refer to
“Utility Mode Operations” in the Advanced Operations volume of the User Man-
ual.
✎
Tip
The memory recall feature cannot be used if any of the following have occurred.
- A new document has been scanned. (The [Start] key has been pressed.)
- The copier has been turned off.
- The [Panel Reset] key was pressed while printing was stopped.
The memory recall feature cannot be used if any of the following have occurred.
- A new document has been scanned. (The [Start] key has been pressed.)
- The copier has been turned off.
- The [Panel Reset] key was pressed while printing was stopped.
To use the memory recall feature
1
After copying is finished, touch
[Job List].
[Job List].
2
Touch [Memory Recall Waiting].
The information for the job still
saved in the memory is displayed.
saved in the memory is displayed.