Daewoo df-4500p-4700p Manuel D’Utilisation

INTRODUCTION

CONNECTIONS

Connections

Connecting Antenna/Cable

Disconnect the antenna/cable from the rear of your TV.

Connect this cable to the jack marked RF IN (FROM ANT.) on
the rear panel of the DVD Recorder+VCR.

If your cable wire is connected to your TV without a converter or descrambler box, remove the coax plug from
your TV and attach it to the RF IN (FROM ANT.) jack on the rear panel of the DVD Recorder+VCR.
Use the supplied coaxial cable to connect between the DVD Recorder+VCR’s OUT (TO TV) jack and the antenna
input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels
(all cable channels).

• There are a variety of ways to connect the DVD Recorder+VCR to your TV and other equipment. Use only one of

the connections described below. Whichever TV connection you use will work with all input sources.

• Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best

connections.

• For better sound reproduction, connect the DVD Recorder+VCR’s AUDIO OUT jacks to the audio in jacks of your

amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 11.

Caution

• Make sure the DVD Recorder+VCR is connected directly to the TV, and the TV is set to the correct video input.
• Do not connect the DVD Recorder+VCR’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.
• Do not connect the DVD Recorder+VCR via your VCR. The DVD image could be distorted by the copy protection

system.

Rear of DVD Recorder+VCR

Antenna

Cable TV
Wall Jack

Flat Wire
(300ohm)

300/75ohm Adapter

(Not supplied)

DF-T35-37D2P-WB 2006.8.24 4:57 PM ˘

` 11 mac001 1200DPI 90LPI