Runco plasmawall sp-42dhd - sp-42dhdxa Manuel D’Utilisation
44
PlasmaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
• Noise Filter: To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
ISF Day - Display Color: Refer to ISF Night - Display Color.
ISF Day - Input Image: Refer to ISF Night - Input Image.
ISF Day - Input Color: Refer to ISF Night - Input Color.
Save ISF Settings: Whenever you make a change to the ISF settings, you should always
save it. Select Save ISF Settings from the ISF Calibration menu to do this. In the event you
ever have to perform a System Reset, you can restore the saved ISF settings by selecting
Restore Saved Settings in the Service menu. (System Reset and Restore Saved Settings
are described on page 47.)
save it. Select Save ISF Settings from the ISF Calibration menu to do this. In the event you
ever have to perform a System Reset, you can restore the saved ISF settings by selecting
Restore Saved Settings in the Service menu. (System Reset and Restore Saved Settings
are described on page 47.)
Output Shift: The controls in the Output Shift menu are similar to those in the Input
Position menu, except that they change the characteristics of the output signal. These
settings are saved independently for each aspect ratio.
Position menu, except that they change the characteristics of the output signal. These
settings are saved independently for each aspect ratio.
Splash Configure: Use the Splash Configure menu to customize the appearance of the
start-up message that appears on the vacuum fluorescent display upon power-up.
start-up message that appears on the vacuum fluorescent display upon power-up.
• Owner Name/ISF Calibrated/ISF Other: You can have the PlasmaWall display the
owner’s name, your name, the phrase “ISF Calibrated” and/or any other string, up to
20 characters in length.
20 characters in length.
Use the up or down cursor button to select a character. Use the right and left cursor
buttons to change the cursor position. Press MENU when you have finished entering
text. Then, check the “Splash Enable” box to have the PlasmaWall display the
information you enter here when it is turned on.
buttons to change the cursor position. Press MENU when you have finished entering
text. Then, check the “Splash Enable” box to have the PlasmaWall display the
information you enter here when it is turned on.
you turn on the PlasmaWall, it projects a welcome screen with the Runco logo followed
by one with the ISF logo. Select Splash Timer from the Splash Configure menu to set
the amount of time that these two images appear. The range is from 2 to 60 seconds,
in one-second increments.
by one with the ISF logo. Select Splash Timer from the Splash Configure menu to set
the amount of time that these two images appear. The range is from 2 to 60 seconds,
in one-second increments.
Use the up or down cursor button to select a timer value to adjust. Use the right or left
cursor button to change the timer value. Press MENU when you have finished
configuring both timers.
cursor button to change the timer value. Press MENU when you have finished
configuring both timers.
OSD Position: Select OSD Position, press ENTER and use the arrow buttons to change
the size and position of the OSD controls.
the size and position of the OSD controls.