Mio miomap-v3.2-c210 Manuel D’Utilisation

 

60 

screen you can see the first page of the top level POI categories. There are three 
levels altogether. 

 

The search will be carried out around a certain reference point. Always look at the 
current reference point shown in the green field above the POI category buttons and 
confirm that it matches what you want. To change the reference, tap the Change ref. 
button in the top right corner. 

 

Once you tap the Change ref. button, you are presented with these choices: 

•  Address: you can specify an address to be searched around, or a settlement to 

search in. The centre of this settlement will be used as the reference point. 

•  History: the reference for the search can be selected from the History list. 
•  Coordinates: you can specify a latitude/longitude pair to be the centre of the 

search. 

•  GPS Position: the search will be carried out around the current location given by 

the GPS if it is available. If no GPS position is available, the last known GPS 
position (grey arrow on the map) will be used. 

•  Cursor: the search will be carried out around the previously selected map point. 
•  Destination: the search will be carried out around the destination of your current 

route. 

The current selection is always shown in the green field at the top of the page. 

Once you have set the reference point, you have the following options on the Find 
POI screen: 

•  Search in POI subgroups: highlight one of the POI groups by tapping or using 

the direction buttons, then press Enter or tap it again to see the list of subgroups. 
Using the same action you can move deeper into subgroups.