Gary Fisher 2004 gary fisher bicycles Manuel D’Utilisation
28
29
CHAPTER THREE
Inspection, Adjustment & Lubrication
To install the Bar-Tab
This attachment is used to attach a
water bottle mount to the Bar-Keeper
accessory rail.
1. Insert the head of the Bar-Tab mounting
bolt (Figure 3.1.9) into the left end of
the Bar-Keeper channel (Figure 3.1.8).
2. Slide the mounting bolt to the desired
location and tighten the thumbwheel.
Figure 3.1.9 Bar-Tab mounting
diagram
diagram
Thumbwheel
Mounting
bolt
Accessory
screws
3. Make sure the Bar-Tab does not move on the Bar-Keeper.
4. Use the two accessory screws to attach the water bottle
4. Use the two accessory screws to attach the water bottle
cage, or other Bar-Tab accessories.
To install a Gary Fisher computer
1. Remove the rubber cover on the right side of the accessory
rail.
2. Identify the computer mounting plate for your computer
type: wired or wireless.
3. Thread the two small front mounting screws several turns
into the underside of the mounting plate.
4. Slide the mount in place.
Hook the two front screws into the slots built into the Bar-
Hook the two front screws into the slots built into the Bar-
Keeper mount.
5. Engage the large central plastic tab.
6. After sliding the computer mount fully into place, install the
6. After sliding the computer mount fully into place, install the
two rear mounting screws.
To install a wrap clamp
Some accessories, like a bicycle computer from a company
other than Gary Fisher, attach to the Bar-Keeper handlebar
with a wrap-around type clamp.
1. Remove the clamp screw from the wrap clamp.
2. Gently spread the wrap clamp and slide over the handlebars
2. Gently spread the wrap clamp and slide over the handlebars
with the screw hole facing forward.
3. Slide the wrap clamp to the desired location.
4. Apply a small amount of grease to the threads and bearing
4. Apply a small amount of grease to the threads and bearing
surfaces of the clamp screw.
5. Attach the desired accessory to the wrap clamp.
6. Make sure the wrap clamp does not move on the Bar-Keeper.
6. Make sure the wrap clamp does not move on the Bar-Keeper.
Handlebars, Bar-ends, and Stem