Metra Electronics 99-7413 Manuel D’Utilisation

DIN HEAD UNITS: Slide the DIN cage into the Housing and secure by bending the metal
locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)

ISO-DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate. Snap the
Faceplate into the Housing and attach the ISO-DIN Spacers to the inner walls of the Mounting
Brackets by inserting the Spacer pegs into the Bracket holes. Slide the aftermarket head unit
into the back of the kit and mount the Brackets to the unit with (4) 5mm Flat-head Screws
supplied. (see Fig. C)

(If an equalizer will be included, slide the unit into the back of the Radio Housing and secure.
If an equalizer will NOT be included, snap the Equalizer Dummy Plate into the opening).

2-SHAFT HEAD UNITS: Snap the Faceplate
into the Radio Housing, slide the aftermarket
head unit into the kit and secure with shaft
nuts. (see Fig. A)

ALL VEHICLES

Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).

A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape

99-7413

INSTALLATION
INSTRUCTIONS

APPLICATIONS

CAR

PAGE

NISSAN
Altima 1993-97........................................................... 1
Altima 1998-01........................................................... 2

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Wrench

Phillips screwdriver

Equalizer
Dummy Plate

(6) #6 Self-tapping
Screws

(4) 5mm Flat-head
Screws

Fig. C

Fig. A

Radio Housing

Faceplate

ISO-DIN
Spacers

Mounting
Brackets

Fig. B

Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) Phillips screws
removed in step #1.

1-800-221-0932 www.metraonline.com

rev. 250701