GE 21115 Manuel D’Utilisation

3.  Press the OK button to confirm. All handsets generate the paging tone for 60 

seconds and display the following message:

If the phone is in use and you press the INTERCOM button on the base unit, the 

display shows:

1. The paging tone volume level is fixed to “High”. You may press 

the EXIT button or any digit on the handset’s touch-tone pad to 

immediately stop the paging tone.

2. Paging tone still sounds even if the Ringer is set to OFF on Handsets.

4.  Press the INTERCOM/PAGE/TRANSFER button on the base again to  

stop paging.

Use the FLASH button to activate custom calling services such as call waiting 

or call forwarding, which are available through your local phone company. If 

you subscribe to the combined Call Waiting Caller ID service from your local 

telephone company, you will receive Caller ID information (if available) on Call 

Waiting calls. During a phone call, you will hear a beep to indicate another call 

is waiting on the line and Caller ID information for the waiting call shows on the 

handset display. To connect to the waiting call.
1.  Press the FLASH button when you hear the call-waiting tone. The first call is 

automatically placed on hold so you can answer the second call.

2.  To return to the first caller, press the FLASH button again. You may switch 

back and forth between the two calls by pressing the flash button.
NOTE: If this function does not operate properly, contact your local 

telephone company.

TIP: Don’t press the TALK button on the cordless handset to activate a 

custom calling service, such as call waiting, or you’ll hang up the phone.

Use the #PAUSE button to insert a delay in the dialing sequence of a stored 

telephone number when a pause is needed (for example, when you must dial 

a 9 to get an outside line or when you must enter codes to access your bank’s 

information line). You may insert a PAUSE when in the directory mode, pre-

dialing mode or Voice Mail and Info Service number memory. Press #PAUSE 

button twice to insert a pause. Pause is displayed as “ P.”