Globalsat Technology bt-359 Manuel D’Utilisation
PAGE 12 OF 13
BT359_GPS_v1.2.1
BT-359 GPS
11. BT-359 SPECIFICATIONS
Electrical Characteristics (Receiver)
GPS Chipset
SiRF Star III e/LP
Frequency
L1, 1575.42 MHZ
C/A Code
1.023 MHz chip rate
Channels
20 all-in-view tracking
Sensitivity
-159 dBm
Accuracy
Position Horizontal
1~ 5m 2D RMS WAAS enabled
10m 2D RMS WAAS disabled
Velocity
0.1m/sec 95% (SA off),
Time
1 micro-second synchronized to GPS time
WAAS
Enabled for North America product s (USGlobalSat, Inc)
Datum
Datum
WGS-84
Acquisition Rate
Hot start
1 sec., average (with ephemeris and almanac valid)
Warm start
38 sec., average (with almanac but not ephemeris)
Cold start
42 sec., average (neither almanac nor ephemeris)
Reacquisition
0.1 sec. average (interruption recovery time)
Protocol
GPS Protocol
Default: NMEA 0183 (Secondary: SiRF binary)
GPS Output Data
SiRF binary >> position, velocity, altitude, status and control
NMEA 0183 MEA0183 V2.2 protocol, and supports
command: GGA, GSA, GSV, RMC, VTG, GLL v2.2 (VTG
and GLL are optional)
NMEA 0183 MEA0183 V2.2 protocol, and supports
command: GGA, GSA, GSV, RMC, VTG, GLL v2.2 (VTG
and GLL are optional)
GPS transfer rate
Software command setting (Default : 38400,n,8,1 for NMEA )
Connection
Communication with host platform via Bluetooth Serial Port
Profile
Profile
Dynamic Condition
Acceleration Limit
Less than 4g
Altitude Limit
18,000 meters (60,000 feet) max.
Velocity Limit
515 meters/sec. (1,000 knots) max.
Jerk Limit
20 m/sec3
Temperature
Operating
14°~ 140°F (-10°~ 60°C)
Storage
-4°~ 158°F (-20°~ 70°C)
Humidity
Up to 95% non-condensing
Power
Voltage
5V ±5%
Battery capacity
1100mAH
Battery Life
11 hours continuous use
Physical Characteristics
Dimension
3.23" x 1.61" x 0.53" (82
mm x 41 mm x 13.4 mm
)
Due to continuous product improvements, all specifications are subject to change without notice.
FCC NOTICE
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference received, including interference that may cause undesired operation.
FCC RF Exposure requirements:
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.