Hitachi 42pd9r10 Manuel D’Utilisation

54

 Position Adjustment

Vertical picture position can be adjusted for Panoramic, Zoom, C14:9L, and 14:9 Zoom mode as follows.

1. Press 

 buttons while operating the picture size display.

2. “Position” display will appear.

3. Adjust the position by 

 buttons.

Adjustment range of each picture size are as shown below.

 

Panoramic:        

-12 to+12  (The position cannot be adjusted in Panoramic 2 mode.)

 

Zoom: -31 

to+ 

31

 

C14:9L and 14:9 Zoom: -16 

to+ 

16

 

*When 1080i/60 component signal is received, it can be adjusted only 0 to +1.

 Size Adjustment

   Full Mode

Whilst displaying a picture of 1080i format in AV4, HDMI1, HDMI2, or RGB input, the full mode can be switched further 
between Full1 and Full2 with 

 buttons on the remote control. 

By selecting Full2, you can see the whole image of 1080i format on the screen display from the input terminals.
Depending on the input signal or connecting device, the screen display has unnecessary blanking or noise at the edges.
Considering the case, the default setting is Full1 which enlarges the vertical size not to display the blanking and noise.

NOTE

 The screen saver function does not work at Full2 mode.
 This function is available only for 42PD9700 U/C.

FUNCTION (continued)

Size Switching (continued)

Position  + 31

Press▲

Position  - 31

Press▼

   Panoramic Mode

Whilst displaying a picture except RGB input, the panoramic mode can be switched further between Panoramic 1 and 
Panoramic 2 with 

 buttons on the remote control.

By selecting Panoramic 2, the vertical size is scaled down so that you can see the whole image without blanking ; for 
example, you can see the subtitle at the bottom of screen without lacking.

NOTE

The function does not work when selecting Auto [Panoramic].