ONKYO ED-205 Manuel D’Utilisation

If your system is totally configured with ONKYO separate
collection series components, you can use the system functions
using the ED-205's supplied remote controller.
Connect all components in series using the z cables, starting
with the amplifier. For components having two z REMOTE
CONTROL jacks, you may use either of them because their
functions are same.
• If your system already has been set up with the ONKYO

separate collection series components, connect the ED-205's
z REMOTE CONTROL jack to the CD player's or tuner's
unused z REMOTE CONTROL jack.

• To operate the system components, point the remote

controller toward the amplifier's remote control sensor.

• To operate the ED-205, point the remote controller toward the

ED-205's remote control sensor.

Notes:
• Do not use the z REMOTE CONTROL jack to connect

products not bearing the z symbol. Doing so may result in
the damage to the equipment.

• Connecting only the z cables is not sufficient for operation

of your system. Connect the components also via audio
connection cables.

• Connect the speaker cables before you connect the z cables.

z

Before plugging in the unit, confirm that all connections have
been made properly.
Turning on this unit’s power may cause a momentary power
surge, which might interfere with other electrical equipment,
such as computers. If so, use a wall outlet on a different circuit.

After plugging the ED-205’s power cord into an AC outlet, press
the POWER switch to put the unit in power-standby status (the
SATNDBY indicator is lit). The remote controller cannot be used
to operate the ED-205 if the POWER switch is not set ON.

When the POWER switch is set ON, pressing the STANDBY/
ON button or the POWER button on the remote controller
switches the ED-205 between standby status (the STANDBY
indicator is lit) and power on status (the display is lit).
Press the POWER switch on the ED-205 to set it to the OFF
position, turning of the unit.

(Tuner)

(Amplifer)

(MD Recorder)

(CD Player)