ONKYO HTP-240 Manuel D’Utilisation

 

5

 

A

 

Red:

 Subwoofer in standby mode

Green:  Subwoofer on

With the Auto Standby function, the SKW-240 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for a while, the SKW-240 automatically 
enters Standby mode.

 

B

 

This control is used to adjust the volume of the sub-
woofer.

 

C

 

This RCA input should be connected to the sub-
woofer preout on your DR-S2.2 DVD Receiver, 
amp, or other receiver with supplied RCA cable.

 

D

 

To turn on the SKW-240, set the POWER switch to 
the ON position (the indicator lights up).
To turn off the SKW-240, set the POWER switch to 
the OFF position (the indicator goes out).

 

The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
your receiver or amp.

 

1

 

These push terminals are for connecting the speaker 
to your DR-S2.2 DVD Receiver, amp, or other 
receiver with the supplied speaker cables. The sup-
plied speaker cables are color-coded for easy identi-
fication. Simply connect each cable to the same-
colored positive speaker terminal.

 

2

 

These keyhole slots can be used to wall-mount the 
speaker either horizontally or vertically.

 

3

 

These threaded inserts can be used to attach the 
speaker either horizontally or vertically to a speaker 
mount or bracket.

 

Use commercially available M5 machine screws (1/
4-inch screws for North American model) to attach 
the speaker to a speaker mount or bracket.

 

4

 

These threaded inserts can be used to mount the 
speaker on the supplied base (screws included).

1

2

3

4

■ Front

■ Rear

To AC outlet

2

4

1

3

HTP-240.fm Page 5 Thursday, April 7, 2005 4:36 PM