ONKYO TX-NR1010 Manuel D’Utilisation

■

`

No 

`

With this setting, a frequency band near the specified 
crossover frequency is output by both tweeters and 
woofers. Based on the frequency selected for “Crossover”, 
the cutoff frequency of the low-pass filter (LPF) will be set 
to 1/3 octave up and that of the high-pass filter (HPF) to 
1/3 octave down. Example: With a “Crossover” of 
“3200Hz”, the cutoff frequency of the woofers’ LPF will 
be “4000Hz”, and the tweeters’ HPF will be “2500Hz”.

• Sounds processed by Digital Processing Crossover Network are 

played.

• You can switch from the current audio source to test noises by 

pressing  MODE/D (Blue).

• In the case of usage of the bi-amped speakers, if there is a 

difference between the crossover frequency in the speakers’ built-
in network and the crossover frequency to be set on the AV 
receiver, the frequency dip may be caused. Therefore, it is 
recommended that this function should be set to “Yes”.

■

`

–6.0dB to 0.0dB to +6.0dB in 0.5 dB steps.

With this setting, you can set the volume of tweeters and 
woofers.

• Sounds processed by Digital Processing Crossover Network are 

played.

• You can switch from the current audio source to test noises by 

pressing  MODE/D (Blue).

■

`

0º 

`

180º:

With this setting, you can adjust the phase of tweeters and 
woofers.

• Sounds processed by Digital Processing Crossover Network are 

played.

• You can switch from the current audio source to test noises by 

pressing  MODE/D (Blue).

■

`

0inch(0.0cm) to 12inch(30.0cm) in 1 inch (2.5 cm) 
steps.

With this setting, you can adjust the virtual position of 
tweeter and woofer units. Adjusting “High Distance” 
virtually shifts woofers behind tweeters. Adjusting “Low 
Distance” virtually shifts tweeters behind woofers.

• Sounds processed by Digital Processing Crossover Network are 

played.

• You can switch from the current audio source to test noises by 

pressing  MODE/D (Blue).

With the Audio Adjust functions and settings, you can 
adjust the sound and listening modes as you like.

■

`

Main 

`

`

This setting determines which channel of a stereo 
multiplex source is output. Use it to select audio channels 
or languages with multiplex sources, multilingual TV 
broadcasts, and so on.

■

`

Left + Right 

`

`

This setting specifies the channel to be used for playing 
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.

(Low Distance)

Tweeter

Woofer

(High Distance)

Distance

Distance

“Setup”