ONKYO TX-NR1010 Manuel D’Utilisation
Advanced Operations
En-85
■
Operating on the AV receiver
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone (
).
■
Operating on the remote controller
To control Zone 2/3, you must press ZONE on the remote
controller first.
ZONE turns red when Zone 2 is on, and green when
Zone 3 is on.
controller first.
ZONE turns red when Zone 2 is on, and green when
Zone 3 is on.
Adjusting the Volume for Zones
■
Operating on the remote controller
■
Operating on the AV receiver
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
Controlling Multi Zone Components
1
To turn on Zone 2/3 and select an input source,
press
press
ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press ZONE 2 or ZONE 3 and
the TUNER input selector repeatedly.
the TUNER input selector repeatedly.
To select the same source as the main room’s, press
ZONE 2 or ZONE 3 twice. “Zone 2 Selector:
Source” or “Zone 3 Selector: Source” appears on the
AV receiver’s display.
ZONE 2 or ZONE 3 twice. “Zone 2 Selector:
Source” or “Zone 3 Selector: Source” appears on the
AV receiver’s display.
ZONE 3
ZONE 2
OFF
MASTER VOLUME
Input selector buttons
2
To turn off Zone 2/3, press
ZONE 2 or ZONE 3.
The Z2/Z3 indicator on the AV receiver’s display
flashes. Press
flashes. Press
OFF.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
1
Press
ZONE repeatedly, then point the remote
controller at the AV receiver and press
8RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
8RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press
ZONE
repeatedly, followed by an
INPUT SELECTOR
button.
To select AM or FM, press ZONE and the TUNER
input selector repeatedly.
To select AM or FM, press ZONE and the TUNER
input selector repeatedly.
8RECEIVER
MUTING
VOL
q/w
ZONE
Input selector buttons
3
To turn off Zone 2/3, press
ZONE repeatedly,
followed by
8RECEIVER.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
1
Press
ZONE repeatedly.
2
Use
VOL
q/w.
1
Press
ZONE 2 or ZONE 3 (the Z2/Z3 indicator on
the AV receiver’s display flashes).
2
Use
MASTER VOLUME control within 8 seconds.