ONKYO dv-cp704s Manuel D’Utilisation

21

Connecting the DV-CP704—Continued

Notes:
• The DV-CP704 supports HDCP (High-bandwidth 

Digital Content Protection), a protection system for 
digital video. HDMI components that you connect to 
the DV-CP704 must also support HDCP.

• The DV-CP704 supports High-Definition Multimedia 

Interface Specification Information Version 1.0.

■ Video
The DV-CP704’s HDMI OUT supports the following 
video resolutions:
• 720 x 480p 60 Hz
• 720 x 576p 50 Hz (Australian model only)
• 1280 x 720p 50/60 Hz
• 1920 x 1080i 50/60 Hz
If the connected HDTV or projector doesn’t support a 
resolution, you may get no picture.
On the DV-CP704, you can select a resolution suitable 
for use with the connected HDTV or projector (see 
page 39).

■ Audio Formats
The DV-CP704’s HDMI OUT supports the following 
audio formats:
• PCM (48 kHz, 44.1 kHz, 96kHz)
• Dolby Digital
• DTS
If your TV only supports HDMI digital audio up to 
48 kHz, change the Linear PCM Out setting to Down 
Sample On (see page 45).
If your TV doesn’t support Dolby Digital, set the Digital/
HDMI Audio Out setting to PCM (see page 45).
If your TV doesn’t support DTS, the DV-CP704 will not 
be able to play DTS format audio or soundtracks. In this 
case, on your DVD-Video disc’s audio setup menu, 
select an audio format other than DTS.

• The remote controller supplied with Onkyo AV 

receiver or amplifiers can be used to control the 
DV-CP704.

• The function of the upper and lower 

 connectors are 

the same. Connect to either one.

• Connecting an 

 cable only does not make the sys-

tem operational. You must also connect the audio 
cables as well.

• For remote control operation, you must make an ana-

log RCA connection between your DV-CP704 and the 
other AV component, even if they are connected digi-
tally.

AV receiver