HTC touch pro 2 Manuel D’Utilisation

14  Appendix

For regulatory identification purposes, your product is assigned a model number of RHOD500.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 

RHOD500.
The Battery Pack has been assigned a model number of RHOD160.

Note  This product is intended for use with a certified Class  Limited Power Source, rated 5 Volts DC, maximum 1 Amp 

power supply unit.

Operation is subject to the following two conditions: (1) this device may not cause interference, and () this 

device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This Category II radiocommunication device complies with Industry Canada Standard RSS-310.
Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 d’Industrie Canada.
The device could automatically discontinue transmission in case of absence of information to transmit, or 

operational failure. Note that this is not intended to prohibit transmission of control or signaling information or 

the use of repetitive codes where required by the technology.

Radiation Exposure Statement:
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-10 and 

had been tested in accordance with the measurement methods and procedures specified in IEEE 158. This 

equipment should be installed and operated with minimum distance 1.5cm between the radiator & your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or 

transmitter.
The County Code Selection feature is disabled for products marketed in the US/Canada.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the 

following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance 

could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and () this device must accept any interference received, including 

interference that may cause undesired operation.