Q-Logic 8200 Manuel D’Utilisation
1–Product Overview
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
SN0054671-00 A
1-11
Boot LUN
Enter to specify the LUN of the boot device. (Depending on your
configuration, it may not be necessary to change this option.)
Enter to specify the LUN of the boot device. (Depending on your
configuration, it may not be necessary to change this option.)
CHAP Type
None—CHAP is not used.
One-Way—Unidirectional CHAP is used.
Mutual—Bidirectional CHAP is used.
Target CHAP Name
Enter to specify the target CHAP name.
Enter to specify the target CHAP name.
Target CHAP Secret
Enter to specify the target CHAP secret.
Enter to specify the target CHAP secret.
Type
Enter to set a function to a particular type.
NIC—NIC protocols will be supported.
None—The function will be disabled.
iSCSI—The function will support iSCSI protocol.
FCoE—The function will support FCoE protocol.
MinBW%
Enter to specify the percentage of bandwidth allocated to the function. The
combined MinBW% values for a port’s functions cannot exceed 100 percent.
combined MinBW% values for a port’s functions cannot exceed 100 percent.
Protocol
The Protocol parameter applies only to only function 0 and function 1.
PXE—PXE will be supported on the NIC.
iBFT—iBFT will be supported on the NIC.
Restore to Non-NIC Partition Settings
Press the ENTER key to restore the NIC partition settings.
NOTE:
Functions 0 through 3 support only NIC or None. Functions 4 and 5 support
NIC, iSCSI, or None. Functions 6 and 7 support NIC, FCoE, or None.
NIC, iSCSI, or None. Functions 6 and 7 support NIC, FCoE, or None.
NOTE:
For an embedded LOM, the Protocol parameter is controlled by the system
BIOS and is non-configurable in the CNA Function Configuration utility.
BIOS and is non-configurable in the CNA Function Configuration utility.