Q-Logic 8200 Manuel D’Utilisation

1–Product Overview
Multi-boot Image for 10Gb Converged Network Adapter—CNA Function Configuration 

1-8

SN0054671-00  B

This section provides detailed configuration information for advanced users who 
want to customize the configuration of the 8200 and 3200 Series Adapters and 
the connected devices. You can configure the adapters using the CNA Function 
Configuration utility. 

To access the CNA Function Configuration utility, press ALT+Q during the adapter 
initialization (it may take a few seconds for the menu to appear). If you have more 
than one adapter, the utility will ask you to select the adapter you want to 
configure. After changing the settings, the utility reboots your system to load the 
new parameters.

Upon entering the CNA Function Configuration utility, the following selections are 
available from the Setup Menu/Function Configuration menu:



 









                                                                                           



If you used an FC RAID target in a cluster environment, you should 

enable the Enable Target Reset = Enabled (Advanced 
Adapter Settings). 



Use the /I option if the update utility, QLflash, does not detect your 

adapter. 



QLogic recommends disabling the internal disk before installing the OS 
or booting to the FCoE disk.

The CNA Function Configuration utility does not run on SUN™ SPARC

®

 

systems.

If the configuration settings are incorrect, your adapter may not function 
properly.