Hitachi c32wf540n Manuel D’Utilisation

GB - 8 -

Before Switching on your TV

Power connection

IMPORTANT: The TV set is designed to operate on 220-240V

AC, 50 Hz.
After unpacking, allow the TV set to reach the ambient room

temperature before you connect the set to the mains.

Aerial Connections

Connect the aerial plug to the aerial input socket located at

the back of the TV.

How to connect other devices

IMPORTANT: Switch off the TV before connecting any exter-

nal device.
Sockets for external connections are on the back of the TV.
For connection of other devices via SCART connector (or

RCA Jack) refer to the manuals of the related devices.

Inserting batteries in the remote control handset

Remove the battery cover located on the back of the hand-

set by gently sliding it in the direction shown below.

Insert two AAA (R03) or equivalent type batteries inside.
Replace the battery cover.

Note: Remove the batteries from the remote control handset

when it is not going to be used for a long time. Otherwise it

could be damaged if the batteries leak.

Switching the TV ON/OFF

You can operate your TV either using the remote control

handset or directly using the buttons on the TV.

To switch the TV on

Your TV will switch on in two steps:
1- Press the power button located on the front of the TV. Then

the TV switches itself to standby mode and the RED LED lo-

cated below the TV turns on.
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a pro-

gramme number is selected,
or,
Press Programme Up and Down buttons on the front of the

TV or on the remote control respectively, so the TV will

switch on and the RED Led will turn GREEN.

To switch the TV off

Press the stand-by button on the remote control, so the TV

will switch to stand-by mode and the GREEN LED will be-

come RED, or,

Press the power button located on the front of the TV.

Operating the TV

You can operate your TV in two ways. First by using the

remote control handset and second by using the controls

on the TV.

APS (Automatic Programming System)

The Auto programming system automatically programmes

your TV according to the correct transmission system in your

area.
When you turn on your TV for the first time, the "Auto Setup''

menu will be displayed. In this menu if the language setting is
incorrect, use either

buttons to highlight "Lan-

guage'' and select the most suitable language using the

buttons. Then use either of the

buttons to highlight "Country". If the country setting is incor-
rect, use either of the

buttons to select the

correct one. Finally use

buttons to highlight

"Start" and press either of the

buttons to start

the "Auto-Programming''. The "Auto-Programming sys-

tem'' (APS) can be cancelled by pressing the "TV'' button lo-

cated on the remote control handset.

When the APS has finished a table of stored stations will be

displayed on the screen with number 1 highlighted in red. In

the table you will see programme numbers and names as-

signed to the stations, they will be listed in a predetermined

order.
If you wish to check the stations press the "

" button to

move the red flashing number and name down to the pro-

gramme you wish to view and press the red button on the re-

mote control hand set to select the programme.

If you would like to change the order of the table, you can

rearrange it. To rearrange the table, press the menu button

to display the install menu, then in the install menu select

the TUNING menu. To use the Tuning menu please refer to

the Tuning sub menu section that is located in the install

menu part of this manual.

After selecting the Tuning Mode if you want to start APS, by

pressing the

buttons, come to the Start item

and by pressing

button start the APS.

IB-ENG-PLL-STEREO-AK33-UK-(C28WF540N-C32WF540N-28&3217W).p65

29.08.2002, 13:06