Hitachi VHS VT-M292A Manuel D’Utilisation
Getting Started
16
Separate UHF and VHF
antenna wires, both 300 ohm
flat wire
flat wire
300 ohm flat UHF and 75 ohm
round VHF
If you have "rabbit ears" (an antenna on top of your TV), you will need an additional
adapter and 75 ohm extension to make your leads reach from the antenna to the VCR.
This connection will work only if you have a strong, clear picture on the TV, indicating a
strong signal. Connect the antenna to the adapter, and use the cable extension to go
from the adapter to the VCR. Use the supplied 75 ohm cable to connect the VCR to the
TV.
adapter and 75 ohm extension to make your leads reach from the antenna to the VCR.
This connection will work only if you have a strong, clear picture on the TV, indicating a
strong signal. Connect the antenna to the adapter, and use the cable extension to go
from the adapter to the VCR. Use the supplied 75 ohm cable to connect the VCR to the
TV.
Now continue with the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the
IN FROM ANT jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO
TV jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the
TV (where you first disconnected the antenna).
1. Using whichever adapter you have fit your antenna with, attach that connector to the
IN FROM ANT jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO
TV jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the
TV (where you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions
provided by this equipment.
provided by this equipment.