ONKYO dr-s501 Manuel D’Utilisation

39

With the built-in tuner you can enjoy AM and FM radio 
stations. You can store your favorite stations as presets 
for quick selection.

■ Auto Tuning Mode

When tuned into a station, the 

 indicator appears. 

When tuned into a stereo FM station, the FM ST indica-
tor appears on the display, as shown.

Note:
This procedure can also be performed on the DVD 
receiver by using its TUNING/PRESET [ ]/[ ] button. 
Press the TUNING/PRESET [ ]/[ ] button to start 
searching for a few seconds. Pressing the TUNING/
PRESET [ ]/[ ] button again stops the searching.
After this, press the button repeatedly to change the fre-
quency one step at a time.

■ Manual Tuning Mode

Radio Frequency can be changed in 0.05 MHz steps for 
FM and 9 kHz steps for AM. You can change the interval 
of the steps for AM frequency (not European models) 
(see page 55).
In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to 
Manual Tuning mode and listen to the station in mono.

select either AM or FM.
In this example, FM has been selected.

(Actual display depends on country)

Band

Frequency

Searching stops when a station is 
found.
To stop searching, press Stop [ ] but-
ton.

The frequency stops changing when 
you release the button.
Press the buttons repeatedly to change 
the frequency one step at a time.