Kenmore 122.1613411 Manuel D’Utilisation

Page de 22
• Have your LP gas tank filled by a reputable 
propane gas dealer and visually inspected and re-
qualified at each filling.
• Do not store a spare LP gas tank under or  
• near this appliance.
• Never fill the tank beyond 80 percent full . If this 
information is not followed exactly a fire causing 
death or serious injury may occur.
• Always keep LP gas tanks in an upright position.
• Do not store or use gasoline or other flammable 
vapors and liquids in the vicinity of this gas grill.
• Do not subject the LP gas tank to excessive heat.
• Never store an LP gas tank indoors. If you store 
your gas grill in the garage or other indoor 
location, always disconnect the LP gas tank first 
and store it safely outside.
• Place dust cap on cylinder valve outlet whenever 
the cylinder is not in use.  Only install the type of 
dust cap on the cylinder valve outlet that is 
provided with the cylinder valve.  Other types of 
caps or plugs may result in leakage of propane. 
• LP gas tanks must be stored outdoors in a well-
ventilated area and out of reach of children. 
Disconnected LP gas tanks must not be stored in 
a building, garage or any other enclosed area.
• When your gas grill is not in use the gas must be 
turned off at the LP gas tank.
• The pressure regulator and hose assembly must 
be inspected before each use of the grill. If there 
is excessive abrasion or wear or if the hose is cut, 
it must be replaced prior to the grill being used 
again.
• Keep the gas pressure regulator hose away from 
hot grill surfaces and dripping grease. Avoid 
unnecessary twisting of hose. Visually inspect the 
hose prior to each use for cuts, cracks, excessive 
wear or other damage. If the hose appears 
damaged do not use the gas grill. Call 1-800-4-
MY-HOME for a replacement hose.
• Never light your gas grill with the lid closed or 
before checking to ensure the burner tubes are 
fully seated over the gas valve orifices.
• Never allow children to operate your grill.
A tank of approximately 12 inches in diameter by 18-1/2 
inches high is the maximum size LP gas tank to use. 
You must use an OPD gas tank which offers an 
Overfill Prevention Device.
This safety feature prevents the tank from being 
overfilled which can cause malfunction of the LP gas 
tank, pressure regulator and/or grill.
The LP gas tank must be constructed and marked in 
accordance with specifications of the U.S. Dept. of 
Transportation (DOT). In Canada, the LP gas tank must 
meet the National Standard of Canada ,CAN/CSA-B339 , 
Cylinders , spheres and Tubes for Transportation of 
Dangerous Goods and Commission .
1. The LP gas tank must have a shutoff valve, 
terminating in an LP gas supply tank valve outlet, that is 
compatible with a Type 1 tank connection device. The LP 
gas tank must also have a safety relief device that has a 
direct connection with the vapor space of the tank.
2. The tank supply system must be arranged for vapor 
withdraw.
3. The LP gas tank used must have a collar to protect the 
tank valve.
Proper Placement and Clearance of Grill 
Never use your gas grill in a garage, porch, shed, 
breezeway or any other enclosed area. Your gas grill is 
to be used outdoors only, at least 24 inches from the 
back and side of any combustible surface. Your gas grill 
should not be used under overhead combustible 
construction . Do not obstruct the flow of ventilation air 
around the gas grill housing.
• Do not install this outdoor gas grill in or on recreational 
vehicles or boats
• Keep outdoor gas grill area clear and free from 
combustible materials, gasoline and other flammable 
vapors and liquids
• Do not obstruct the flow of combustion and ventilation 
air. Check for this each time prior to using grill.
• Never connect an unregulated LP gas tank to your gas 
grill. The gas pressure regulator assembly supplied with 
your gas grill is adjusted to have an outlet pressure of 11”
water column (W.C.) for connection to an LP gas tank.
• Only use the pressure regulator and the hose assembly 
supplied with your gas grill. Replacement pressure 
regulators and hose assemblies must be those specified 
in this manual.
3
Precautions
Always keep the LP cylinder at 
90° (upright) orientation to 
provide vapor withdraw.