Crestron cnxenet plus Manuel D’Utilisation
Crestron CNXENET+
CNX Enhanced Ethernet Expansion Card
TCP/IP Server Symbol Signal Descriptions
SIGNAL(S)
DESCRIPTION(S)
INPUT
TX$ (Digital): This signal is data that is going to a client
symbol connected to this server symbol.
symbol connected to this server symbol.
OUTPUTS
Connect-F (Digital): This signal is high while the socket is
connected and low when the socket is disconnected.
RX$: This signal is data that is coming from a client symbol to
this server symbol.
connected and low when the socket is disconnected.
RX$: This signal is data that is coming from a client symbol to
this server symbol.
PARAMETERS
Port: A 16-bit number that specifies which port the connection
is taking place on. In combination with the IP ID Address, this
specifies a socket.
is taking place on. In combination with the IP ID Address, this
specifies a socket.
Detail View of the TCP/IP Client Symbol in SIMPL Windows’ Programming Manager
TCP/IP Client Symbol Signal Descriptions
SIGNAL(S)
DESCRIPTION(S)
INPUTS
Connect (Digital): A level-sensitive digital signal. When high,
the client attempts to connect the socket. If the connection
cannot be made, the client will retry automatically. When the
signal is low, the client disconnects the socket (if it was
connected) and stops trying to connect.
TX$ (Serial): This signal is data that is going to a server
symbol connected to this client symbol.
the client attempts to connect the socket. If the connection
cannot be made, the client will retry automatically. When the
signal is low, the client disconnects the socket (if it was
connected) and stops trying to connect.
TX$ (Serial): This signal is data that is going to a server
symbol connected to this client symbol.
OUTPUTS
Connect-F (Digital): This signal is high while the socket is
connected and low when the socket is disconnected.
RX$ (Serial): This signal is data that is coming from a server
that is connected to this client symbol.
connected and low when the socket is disconnected.
RX$ (Serial): This signal is data that is coming from a server
that is connected to this client symbol.
PARAMETERS
Port: A 16-bit number that specifies which port the connection
is taking place on. In combination with the IP ID Address, this
specifies a socket.
is taking place on. In combination with the IP ID Address, this
specifies a socket.
Control System Ethernet Setup
This section explains how to configure a control system to communicate over
Ethernet using standard IP. These procedures assume that the CNXENET+ has been
physically installed, added to the control system through SIMPL Windows, and the
control system has been powered up.
Ethernet using standard IP. These procedures assume that the CNXENET+ has been
physically installed, added to the control system through SIMPL Windows, and the
control system has been powered up.
Operations & Installation Guide – DOC. 8153A
CNX Enhanced Ethernet Expansion Card: CNXENET+
• 11