Hanna Instruments c 99 Manuel D’Utilisation

7

Note: The secondary LCD below shows a generic "P– –", whereas the

meter will indicate the exact program number (e.g. in C 200,

"P1" for Aluminum).

Sampling in progress. This flashing

prompt appears each time the meter is

performing a measurement.

The microprocessor is adjusting the light
level, indicated by a scrolling "SIP".

This indicates that the meter is in a zeroed
state and measurement can be performed.

The blinking "LOBAT" indicates that the
battery voltage is getting low and the
batteries need to be replaced.

The light level is accepted. The instrument
is ready to perform a zero reading. This
flashing prompt will only appear when a
second zero reading needs to be performed.
Follow the measurement procedure de-
scribed in the related chapter.

The instrument is performing an internal
check-up.

This indicates that the meter is in a ready
state and zeroing can be performed.

This indicates that the batteries are dead
and must be replaced.