Roland FJ-50 Manuel D’Utilisation
31
2 Basic Operation
2-7 Ending Printing Operations
If you wish to cut off the piece of the rolled material
containing the printed area, press the [SHEET CUT]
key. Hold down for about 2 second.
The piece is cut off at the present location of the
printing-start line.
containing the printed area, press the [SHEET CUT]
key. Hold down for about 2 second.
The piece is cut off at the present location of the
printing-start line.
* This operation isn't
necessary when sending a
material-cutting command
from the computer to
separate the material
automatically.
material-cutting command
from the computer to
separate the material
automatically.
1
Press the [SETUP] key. Hold down for about 1
second.
second.
2
Move the sheet loading lever toward the back of the
unit.
The pinch rollers rise to release the material.
unit.
The pinch rollers rise to release the material.
3
Remove the Material
Open the front cover.
To remove the material, follow the steps for loading it
in reverse.
To remove the material, follow the steps for loading it
in reverse.
4
Separating the Printed Portion
Either of two methods can be used to separate a portion that's already been printed from the roll. One method is to press the [SHEET
CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 2 seconds or longer severs the material at the present position of the printing-start line.
Sheet loading lever
The material is cut off here.
Knife guide
Printed portion
Printing-start line
The SETUP LED goes out