Hobart ML-136135 Manuel D’Utilisation
– 4 –
INSTALLATION
UNPACKING
Immediately after unpacking the slicer, check for possible shipping damage. If the slicer is found to be
damaged, save the packaging material and contact the carrier within 15 days of delivery.
damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installing the slicer, test the electrical service to assure it agrees with the specifications on the
machine data plate. The data plate is located on the left side of the slicer base.
machine data plate. The data plate is located on the left side of the slicer base.
PRODUCT TRAY
The P
RODUCT
T
RAY
(Fig. 1) must be installed.
Fig. 1
Fig. 2
PRODUCT TRAY
TILTED TO THE RIGHT
KNOB
SUPPORT
ARM
ARM
To remove the P
RODUCT
T
RAY
, turn the K
NOB
on the
S
UPPORT
A
RM
counterclockwise a quarter turn. The
K
NOB
is spring-loaded and will pop outward. Tilt the
P
RODUCT
T
RAY
to the right, away from the G
AUGE
P
LATE
(Fig. 2). Then hold the P
RODUCT
T
RAY
with both hands
and lift upward (Fig. 3).
GAUGE PLATE
SUPPORT
ARM
ARM
SHARPENER
PRODUCT
TRAY
TRAY
KNOB
INDEX
KNOB
KNOB
Fig. 3
SUPPORT ARM
CARRIAGE
HINGE PIN
HINGE PIN
BOTTOM OF
SUPPORT ARM
KNOB
To install the P
RODUCT
T
RAY
on the slicer,
lower the bottom of the S
UPPORT
A
RM
onto
the C
ARRIAGE
H
INGE
P
INS
(Fig. 3). Tilt the
P
RODUCT
T
RAY
toward the G
AUGE
P
LATE
. Press
the K
NOB
on the S
UPPORT
A
RM
, and rotate it in
either direction until the K
NOB
is against the
S
UPPORT
A
RM
. Then, turn the K
NOB
clockwise
a quarter turn until snug.