VTech cs6328-2 Manuel D’Utilisation

4

Once you have installed the battery, the screen indicates the battery status 

(see the table below). If necessary, place the handset in the telephone base 

or charger to charge the battery. For best performance, keep the handset in 

the telephone base or charger when not in use. The battery is fully charged 

after 16 hours of continuous charging. See the table on page 45 for battery 

operating times.
If the screen is blank, you need to charge the handset without interruption for 

at least 10

 minutes to give the handset enough charge to use the telephone 

for a short time. When the battery is low, the handset beeps four times every 

minute, shows 

LOW BATTerY and a flashing   icon. If you are on a call in 

low battery mode, the handset has four short beeps to alert you.

The following table summarizes the battery charge indicators and actions  

to take.

Battery indicators

Battery status

Action

The screen is blank.

Battery has no charge 

and the handset cannot 

be used.

Charge without interruption (at 

least 10 minutes).

The screen shows 

and   flashes.

Battery has very little 

charge and the handset 

cannot be used.

Charge without interruption (at 

least four minutes).

The screen shows 

LOW BATTerY and  

 flashes. The handset 

beeps four times every 

minute.

Battery has enough 

charge to be used for a 

short time.

Charge without interruption until 

the screen shows 

hANDSeT X 

(about 30 minutes).

The screen shows 

hANDSeT X.

Battery is charged.

To keep the battery charged, 

place it in the telephone base 

or charger when not in use.

If you do not plug in the battery into the handset and place it in the telephone base 

or charger, the screen displays 

NO BATTerY.