Radio Shack et-905 Manuel D’Utilisation
12
4. Press
MEMORY
again. All indica-
tors turn off, and a tone sounds
that means the number was suc-
cessfully stored.
that means the number was suc-
cessfully stored.
To dial the number, when you have a
dial tone, simply press
dial tone, simply press
DD
on the
handset. The number stored in DD is
automatically dialed.
automatically dialed.
MEMORY OPERATION
You can store 20 numbers (up to 21
digits each) and then dial them by
pressing just a few buttons.
digits each) and then dial them by
pressing just a few buttons.
Storing a Number in
Memory
Memory
Note: You must complete the steps
below within 10 seconds of each oth-
er or you will have to begin again at
Step 1.
below within 10 seconds of each oth-
er or you will have to begin again at
Step 1.
1. Press
MEMORY
on the handset.
The TALK indicator blinks.
(illus)
2. Enter the memory location num-
ber where you want to store the
phone number. The TALK and
BATT LOW indicators blink.
phone number. The TALK and
BATT LOW indicators blink.
(illus)
Note: You must press two digits
(01-20).
(01-20).
3. Enter the phone number you
want to store (up to 21 digits).
4. Press
MEMORY
again. You hear
a tone, and all indicators turn off.
To store additional numbers, repeat
Steps 1–4.
Steps 1–4.
To change a number, simply store a
new one in its place.
new one in its place.
Note: Record the name associated
with the stored phone number next to
the corresponding memory location
number on the memory directory
card. Use a pencil in case you want
to change the name later.
with the stored phone number next to
the corresponding memory location
number on the memory directory
card. Use a pencil in case you want
to change the name later.
43-1080.fm Page 12 Tuesday, August 17, 1999 1:51 PM