Hoshizaki f043-809 kmd-410mwh Manuel D’Utilisation

49 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
8) Connect the bin control connector to the side of the control box. 
 
9) Replace the water tank, cube guide, pump motor bracket, pump motor and float switch in 

their correct positions until they snap in place. 

 

 
Be sure to let the discharge hose pass behind the copper tube and connect it 
securely in position. Otherwise, the discharge hose may be caught in the front 
insulation, leading to improper results. 

 
 
10) Secure the pump motor bracket with the two thumbscrews. 
 
11) Reconnect the pump motor connector and float switch connector. 
 
12) Replace the front insulation and front panel in their correct positions.

 

 
13) Turn on the power supply. 
 
 

 

 
1) Turn off the power supply. 
 
2) Remove the panels. 
 
3) Disconnect the connector of the thermistor lead (orange). 
 
4) Remove the ties, insulation, thermistor holder, and thermistor in this order. 
 
5) Remove the old sealant from the thermistor holder and suction pipe. 
 
6) Wipe off any moisture or condensation from the suction pipe surfaces. 
 
7) Press a tube of the sealant KE 60RTV, manufactured by Shin-Etsu Silicones, to the 

recess of the thermistor holder. Slowly squeeze the sealant out of the tube and spread it 
smoothly in the recess. Do not use any sealant other than the above.