Crestron ig adagio label strip Manuel D’Utilisation

Congratulations on purchasing your custom-engraved label strip from Crestron. Prior to installing your new 
label strip, you must first remove the label strip that is included from the factory. The only tool required is a 
small flat-edged screwdriver approximately 1/8” to 1/4" wide (or other flat-bladed tool). 

1.  Remove the blank label with a small, flat-head screwdriver. The blank label is magnetically attached to 

the front panel of the Adagio component. The label strip will be exposed. 

2.  Insert the screwdriver behind the label strip as shown in the diagram below. 

 

3.  Continue sliding the screwdriver behind the label strip until the top of the label strip slides out as shown 

below. 

 

4.  Continue sliding the screwdriver until the entire top of the label strip is visible. Remove the label strip by 

pulling the top of the label strip up from the Adagio component as shown below. 

 

5.  Repeat steps 1 through 4 for any other label strips. 

 

•  1