kb-electronics kbrf-200a Manuel D’Utilisation

for

Variable Speed Motor Controls

Rated 24 Amps AC @ 115/230 VAC –50/60 Hz

Model KBRF-200A   KB Part No. 9945C

KB Electronics, Inc.

Coral Springs, FL USA 33065

4

Mount the KBRF-200A on a flat surface using the 2 mounting tabs.  (See fig. 1, p. 3.)  Be sure

unit is not exposed to environmental conditions which will adversely affect its operation such

as water, excessive temperature or metal chips.

IV. WIRING – (See fig. 2, p. 4.)

a) Wire KBRF-200A Filter to control using 1/4" – QD terminals.  Wires should be as short as

possible and may have to be shielded with the shield grounded (earthed) at both ends.

b) Wire AC Line to filter using 1/4" – QD terminals.  Shielded wiring is normally  not

necessary for the AC Line.  Be sure to connect ground wire to 4 mm ground stud (Earth)

on 

KBRF-200A Filter.

RFI/EMI CONSIDERATIONS
a) It may be necessary to shield the motor speed control or mount it in a metal enclosure to

reduce radiated EMI.

5